Details 38 used
Promo Detail: Redeem this great 10% Off coupon at Decorative ceiling tiles once you make the shopping and check out.
What are the costs involved?
This will depend on the material, size, depth and amount of the tiles you will need to create. They will gladly give you a quote, please submit your art and any details you have.
What are the dimensions of your Styrofoam Ceiling Tiles?
Styrofoam Ceiling Tiles are 19 5/8 x 19 5/8 squares and the thickness is about 1/4 of an inch including the design. The square footage of each tile is about 2.69 sq.ft.
Can I paint The Styrofoam Ceiling Tiles and what paint should I use?
Yes, you can paint our Styrofoam ceiling tiles but make sure that you are using a water-based paint only. Tiles can be brushed, rolled or sprayed with HVLP ( High Volume Low Pressure) sprayer. Again, remember not to use any spray cans or solvent based paints as they will dissolve your tiles.
What are the dimension of Faux Tin Ceiling Tiles?
Their Faux Tin Ceiling Tiles are 2ft x 2ft. Drop in Faux Tin Ceiling Tiles Are about 23 3/4 x 23 3/4. Glue up Faux Tin Ceiling Tiles could be little bigger than 24x24, some designs could be about 24 3/8 x 24 3/8 including the overlapping edge. The depth on the design varies from one design to another. Their deepest tiles are the design 210, they are about 1 inch deep.
Should I paint Styrofoam ceiling tiles before or after installation?
You can do it before or after installation and each method has its pros and cons. If you choose to paint your tiles before installation, keep in mind that you will need a fairly large area for your tiles to dry for at least couple of hours.
Also, if you are painting your tiles before installing them and the color is blue for example, unless your caulk is tinted to that specific color you will have to paint the caulk with a brush to match, after the tiles are up and the caulking is dry ( this process is not really hard at all, just make sure to mix the paint with little bit of water/ Floetrol so that it lays nicely and does not dry too quick and leaves brush marks).
How do I install Styrofoam ceiling tiles around lights, vents and fans?
Most of the time it works like this. Before you start installing your tiles, lights, fans and vents get removed. After you remove the light and fans(make sure your power is off), cover the wires with proper covers and push them deep into the housing.
Once the wires are deep in the housing, you can install your tile over the wire housing and then just feel out the hole above it and use your razor knife to cut around it. Vents are are same, just make sure to turn your air conditioning or heating off so that you can install your tiles